HP 6200 - Manual (Page 51)

◦ Hold the drive and bracket firmly together and turn the assembly over. Install four M3
screws to secure the drive to the bracket.
Figure 2-28 Securing the Drive in the Adapter Bracket
● If you are installing the drive in the upper bay (bay 4), install three standard 6-32 silver
guide screws (two on the right side and one on the left side in the screw hole closest to the
power and data connectors).
Figure 2-29 Installing Standard Guide Screws
7. Insert the hard drive into the bay as follows:
ENWW Installing Drives 43