Holder C-Trac 4.74 - Manual (Page 153)

C 4.74
Operating instructions
152 149 443
General remarks on maintenance
• Do not run engine in enclosed spaces! Danger of
poisoning!
• To prevent the danger of fire, keep the vehicle and
implements clean!
• When leaving the vehicle, secure it against rolling and
unauthorized use (parking brake, chocks), stop the
engine, remove the ignition key and, if required, lock the
cabin!
• Never leave the vehicle unattended while the engine is
running!
• If external power loads are connected, eg equipment
with solenoid valves, protect them with diodes against
back currents. If not, the traction electronics could be
affected.
• Operate the equipment only if all guards are installed
and in position.
• Install and remove the articulated shaft only with the
engine stationary.
• When working with the PTO shaft, no-one should be
standing in the area of the rotating PTO and articulated
shaft.
• The guards for the articulated shaft and the PTO shaft
must be installed as specified.
• When the articulated shaft is removed, refit the protec-
tive cap on the PTO shaft.
• Do not perform any welding, cutting and grinding work
on carrying and other safety-relevant parts such as
vehicle frame, axles, trailer hitch, etc.
• When doing electric welding, disconnect all connector
plugs from the electronic units.
• The mounting of tires requires sufficient knowledge and
special mounting tools.
• Only use genuine HOLDER replacement parts! Use the
parts in the list of maintenance parts in the chapter
entitled “Maintenance data“.
• The vehicle and the implement must be checked for
road worthiness and operating safety before taking it
into operation and after servicing or repairs.