Holder C-Trac 4.74 - Manual (Page 58)

Operating instructions
149 443 57
C 4.74
Taking into operation
Km/h 0000000 h
25
15
FRONT
540U/min
1000U/min
20
5
10
30 RPMx100
PTO
electronic
0
Motor
digital system
1
2
5 9 6 7 8 10
Bild_C164
- Turn the ignition key to position 2.
The engine is being preheated. The preheating indica-
tor (5) comes on.
NOTE
When starting at low temperatures, hold the
ignition key longer (approx. 1 minute) in posi-
tion 2.
- When the preheating indicator extinguishes, turn the
ignition key to position 3 to start the engine.
The engine starts.
ATTENTION
Operate the starter for a maximum of 20 sec-
onds. Wait one minute before repeating the start-
ing procedure. Repeat the starting procedure only
twice at most. In case the engine does not start,
carry out a troubleshooting according to the
section entitled “Troubleshooting guide“.
- Release the ignition key after the start.
The battery charging indicator (7) and the engine oil
pressure indicator (6) extinguish.
- Set the engine speed with the hand throttle button or
accelerator pedal to the desired rpm (9).
- The hour meter (10) is activated.