Hearth and Home Technologies QUADRA-FIRE 823-0170 - MBK - Manual (Page 14)

R
Page 14 250-5763F March 21, 2013
Isle o ale oo to e
O In Canada when using a factory-built chimney it must
be safety listed, pe 1 3 21 o F or
conforming to 2 D D FO o
F O B I I .
i ne e uire ents
Floor
Protector
Chimney
Connector
Insulated " T "
Flashing
Listed Termination Cap
Trim Collar on
Inside Wall Listed Chimney
Storm Collar
Wall Support
Roof Brace (if required)
Thimble
Floor
Protector
Chimney
Connector
Ceiling Support
Listed Chimney
Listed Termination Cap
Storm Collar
Flashing
Figure 1 .1 refa ri ate terior i ne
Figure 1 .2 refa ri ate Interior i ne
. enting o ponents
i ne onne tor
,WLVDOVRNQRZQDVÀXHSLSHRUVWRYHSLSH7KHFKLPQH\
FRQQHFWRUMRLQVWKHVWRYHWRWKHFKLPQH\,WPXVWEHDLQFK
(152mm) minimum diameter 24 gauge mild steel black or
26 gauge blued steel, or an approved air-insulated double
wall venting pipe.
i le:
$ PDQXIDFWXUHG RU VLWHFRQVWUXFWHG GHYLFH LQVWDOOHG LQ
combustible walls through which the chimney connector
passes to the chimney. It is intended to keep the walls
from igniting. Site constructed thimbles must meet
1)3$  6WDQGDUGV  3UHIDEULFDWHG PXVW EH VXLWDEOH
IRU XVH ZLWK VHOHFWHG FKLPQH\ DQG PHHW 8/ 7\SH
HT Standards. Follow instructions provided by the
manufacturer for manufactured thimbles for masonry
chimney and prefabricated chimneys.
i ne :
The chimney can be new or existing, masonry or
prefabricated and must meet the following minimum
UHTXLUHPHQWVVSHFL¿HGLQ6HFWLRQ%
B. i ne ste s
‡ 0XVW EH PLQLPXP  LQFK PP  GLDPHWHU ,'  KLJK
WHPSHUDWXUHFKLPQH\OLVWHGWR8/+7  o
F) or
8/&6 0
‡ 0XVWXVHFRPSRQHQWVUHTXLUHGE\WKHPDQXIDFWXUHUIRU
installation.
‡ 0XVWPDLQWDLQFOHDUDQFHVUHTXLUHGE\WKHPDQXIDFWXUHU
for installation.
‡ 5HIHUWRPDQXIDFWXUHUVLQVWUXFWLRQVIRULQVWDOODWLRQ
refa ri ate etal i ne