HP AFICIO SP 8100DN - Manual (Page 48)

Attaching IEEE 1284 Interface Board Type A
37
2
D
Fully insert the 1284 interface board into the slot.
Confirm that the 1284 interface board is firmly connected to the controller
board.
E
Tighten the two screws to secure the 1284 interface board.
Note
❒ Use the supplied adaptor to make the connection with the computer.
❒ After finishing installation, you can check the 1284 interface board is prop-
erly installed: Print the configuration page from the [List/Test Print] menu.
If it is installed properly, “Parallel Interface” will appear for “Device Con-
nection” on the configuration page.
❒ If the 1284 interface board is not installed properly, reinstall it following
this procedure. If you cannot install it properly even after attempting rein-
stallation, contact your sales or service representative.
Reference
For printing the configuration page, see “Printing the Test Page”, Quick In-
stallation Guide.
AQV513S
AQV524S