HP AA-RTDRB-TE - Manual (Page 128)

Error Messages
128 Embedded Web Server User Guide
Error 136: Invalid
Number of Switch
Membership List Entries
The number of switch
members submitted
exceeds the maximum
allowable entries of 256.
The number of entries in
the switch membership list
is limited to 256. Make
sure that the list (including
the managed switch)
contains no more than
256 entries.
Error 137: Invalid Fabric
Binding State
The fabric binding state
submitted is not
recognized by the CLI.
The fabric binding state
must be set to either
inactive
or
restrict
.
Error 138: Invalid Switch
Binding State
The switch binding state
submitted is not
recognized by the system.
The switch binding state
must be set to one of the
following: disable,
erestrict
,
frestrict
, or
allrestrict
.
Error 139: Insistent
Domain ID's Must Be
Enabled When Fabric
Binding Active
The user attempted to
disable insistent domain
ID's while fabric binding
was active.
Insistent domain ID's must
remain enabled while
fabric binding is active. If
fabric binding is set to
inactive, the insistent
domain ID state may be
changed. It should be
noted, however, that this
can be disruptive to the
fabric.
Error 140: Invalid Insistent
Domain ID State
The request cannot be
completed because an
invalid insistent domain
ID state has been
submitted.
The insistent domain ID
state must be set to either
enable or disable.
Error 141: Invalid
Enterprise Fabric Mode
The request cannot be
completed because an
invalid enterprise fabric
mode has been
submitted.
The enterprise fabric
mode must be set to either
activate or deactivate.
Error 142: Invalid
Domain RSCN State
The request cannot be
completed because an
invalid domain RSCN
state has been submitted.
The domain RSCN state
must be set to either
enable or disable.
Table 9: Embedded Web Serve Messages (Continued)
Message Description Action