HP AA-RTDRB-TE - Manual (Page 133)

Error Messages
133 Embedded Web Server User Guide
Error 219: Invalid Port
Type
The port type configured
is invalid.
A port may be configured
to be an eport, gport, or
fport. Be sure the port is
configured appropriately
and resubmit the
command. On the Edge
Switch 2/24 only, fxport
and gxport types are also
supported.
Error 222: Invalid SNMP
Community Index
The value entered for the
SNMP community index
is invalid.
The SNMP community
index must be an integer
in the range 1–6. Make
the appropriate changes
and resubmit the
command.
Error 223: Unknown Error The switch did not accept
the request
Contact your service
representative.
Error 224: Invalid
Argument
One or more parameters
are invalid for this
command.
For the appropriate
parameters, see the
section of the manual that
corresponds to the
attempted command.
Error 225: Argument
Does Not Contain All
USASCII Characters
The argument contains
non-USASCII characters.
For the appropriate
parameters, see the
section of the manual that
corresponds to the
attempted command.
Error 226: Argument Is
Too Long
One or more parameters
are invalid for this
command.
For the appropriate
parameters, see the
section of the manual that
corresponds to the
attempted command.
Error 227: Invalid SNMP
Community Name
The value entered for the
SNMP community name
is invalid
The community name
must not exceed 32
characters in length.
Duplicate community
names are allowed, but
corresponding write
authorizations must
match. Enter an
appropriate SNMP
community name and
resubmit.
Table 9: Embedded Web Serve Messages (Continued)
Message Description Action