haier DW-7777-01 - Manual (Page 13)

English
12
hElpful TIp:
Wiring the dishwasher will be easier if you route wire
into the cabinet opening from the left side.
3. DIREcT WIRE mEThoD:
Cut a 3/4” (1.9cm) hole ”C” in right hand cabinet side,
rear or floor. Optional locations are shown. Wood
Cabinet: Sand hole until smooth.
3a. poWER supplY coRD mEThoD:
Cut a 11/2”(3.8cm) hole “D”in right-hand cabinet rear
or side. Optional locations are shown. Wood cabinet:Sand hole until smooth.
4. Run wire into house wiring junction box. Use strain relief method provided
with junction box. If no strain relief is provided, install
a UL-listed/CSA-certified clamp connector for flexible-
type wire. If installing conduit, attach a UL-listed/CSA-
certified conduit connector to junction box.
4a. Install a mating, three-prong, grounding-
type wall receptable “E”in the cabinet next to the
dishwasher opening. Go to step 6.
5. Run other end of wire through cabinet hole.
Cable must extend to the left front of cabinet
opening. Go to step 6.
Install a mating, three-prong, grounding-type wall
receptacle “E”in the cabinet next to the dishwasher
opening. Go to step 6.
WATER lINE
6. Cut a 1/2”(1.3 cm) minimum hole “F” in left-hand
cabinet side,rear or floor. Optional locations are shown.
(The hole “F” is about 1-3/5” higher than hole “C” or
hole “D”)
7. Measure total length of copper tubing “G” required.
attach copper tubing to water line with manual shut-
off valve. Carefully feed copper tubing through hole in
cabinet (copper tubing will bend and kink easily) until
it is far enough into the cabinet opening to connect it to
dishwasher inlet on the front left of dishwasher.
hElpful TIp:
Routing the water line through the left side of
cabinet opening will make water connection easier.
E