haier DW-7777-01 - Manual (Page 23)

English
22
DRAIN coNNEcTIoN
7. To help minimize vibration noise, route drain
hose to avoid contact with motor. door springs,
water line, cabinet, flooring or the edge of the hole
where it passes though the cabinet. Do not remove
drain loop “n” from side of dishwasher.
8. Place the smaller drain hose clamp “n” onto the
small end of the drain hose “O”. Remove the plug
from the connector”P”.
9. Push the drain hose into the connector “P” up to
the rib “O” on the drain hose.
10. Use pliers to open clamp “n” and slide clamp
onto connector “P” between ribs “O” on connector.
sEcuRE DIshWAshER
1. Open dishwasher door and place towel “a”
over pump assembly and spray arm of dishwasher.
This will prevent screws from falling into pump area
when secure dishwasher to countertop.
2. Check that dishwasher is still level and centered.
3. Secure dishwasher to countertop with two, no.
ST4.2 x 18 Phillips-head screws “B”. The dishwasher
MUST be secured to keep it from tipping when door
is opened. Do not drop screws into bottom of the
dishwasher.
4. Open door about 3 inches (7.6 cm) and check
that space between inner door and tub is equal on
both sides. If spacing is not equal, loosen bracket
screws. If securing to sides of cabinet, replace the
plastic buttons “C”.
Check that top of door does not contact screws,
brackets, or countertop. If it does, dishwasher must
be lowered and re-elevated. Remove paper towel
from dishwasher.
Tip over hazard
Do not use dishwasher until completely installed. Do
not push down on open door. Doing so can result in
serious injury.
WARNING
A