HP J4367A User Manual
Hp ups management module user guide
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- HP UPS Management Module User Guide
- Notice
- Contents
- Overview
- Component identification
- Installing the HP UPS Management Module
- Installing the HP UPS Power Protection Agent
- Installation overview
- Installing the agent on Windows operating systems
- Reconfiguring the agent on Windows operating systems
- Installing the agent on Linux operating systems
- Reconfiguring the agent on Linux operating systems
- Installing the agent on HP-UX operating systems
- Reconfiguring the agent on HP-UX operating systems
- Uninstalling components from Windows® systems
- Uninstalling components from Linux systems
- Uninstalling components from HP-UX systems
- HP UPS Management Module web interface
- HP UPS Management Module web interface overview
- Accessing the web interface
- Signing in to the web interface
- Browser security alert
- Navigating the web interface
- Home tab
- Logs tab
- Setup tab
- Help tab
- HP UPS Management Module Service Menu
- Troubleshooting
- ASCII character sequence Esc+Shift+9 directs all serial communication to the iLO port for the HP ProLiant DL380 G4
- Agent does not install on RH Itanium
- Attached device communication errors appear
- Attached device did not shut down gracefully
- Battery Test did not run
- Browser does not display the web interface for an installed
- Browser incorrectly displays English or Japanese characters
- Certificate error
- Email notifications are not received from an HP-UX server
- Error LED illuminates or flashes
- Event notification messages do not appear on console screen
- Event notifications are not being sent
- FTP error messages appear when connecting through Linux
- Flash update fails over a serial connection
- HP SIM lists a discovered UPS as Unmanaged in the System Type column
- HPFlash does not install image.bin on a Pentium III
- Initiate Battery Test Command Has Been Sent message not displayed
- Input frequency shows zero
- InstallShield error code -6001 appears during setup
- Invalid IP address
- Links in traps and emails do not work correctly for Linux
- Linux agent does not execute on Red Hat 5
- Low battery warning is displayed
- Manual Load Dumped alarm not working
- Messages from the Messenger Service are not displayed in Japanese
- Network attached UPS not discovered
- No power
- Non-admin users cannot log in through telnet
- On battery alarm
- On boost alarm
- On buck alarm
- Operating system firewall prevents management module functionality
- Overload alarm
- Receiving a security error
- Redundant status error displays on the Attached Devices screen for a nonredundant configuration
- Redundant UPS status
- SLES 10 agent does not autostart after power fail or reboot
- Servers running Windows® Server 2003 do not restart
- Shutdowns not functioning when Any Server is configured in a redundant configuration
- Silent install did not execute successfully
- Task Bar menu does not clear
- UPS Power Protection Agent does not display a shutdown warning message in SLES operating systems
- Unable to discover a UPS
- Unable to edit devices using telnet
- Unable to locate the .INI files for a silent install
- Unable to obtain a valid network address error message displays
- Unable to reboot the machine
- Unable to set event delays using telnet
- Unable to start the HP UPS Power Protection Agent for Linux
- Unexpected problems occur with the web interface and Service menu
- Utility alarm
- When resetting or powering on the management module, the browser does not display the web interface
- Technical support
- Regulatory compliance notices
- Alert messages
- Systems Insight Manager integration
- Security considerations
- Optional power monitoring using SNMP
- Updating the firmware
- Redundant configuration
- Mass configuration
- Acronyms and abbreviations
- Index