HP 288048 User Manual
Automatic airless spray guns, Instructions - parts
Advertising
311053C
Instructions - Parts
Automatic Airless
Spray Guns
Part No. 288048
For airless spraying of paints and coatings.
Part No. 288554
For sealant streaming applications.
4000 psi (28 MPa, 280 bar) Maximum Working Fluid Pressure
Mounting manifolds must be ordered separately. Refer to Parts section.
Important Safety Instructions
Read all warnings and instructions in this manual.
Save these instructions.
TI8089a
Model 288048 Shown
II 2 G c T6
Advertising
Table of contents
Document Outline
- Related Manuals
- Warnings
- Installation
- Ventilate Spray Booth
- Configure Gun and Manifold
- Install Air Fittings
- Ground System
- Mount Gun
- Setup
- Air Line and Accessory Recommendations
- Fluid Line and Accessory Recommendations
- Flush Spray Gun
- Install Spray Tip
- Adjust Spray Pattern
- Adjust a Streaming Tip
- Operation
- Pressure Relief Procedure
- Apply the Fluid
- Daily Gun Care
- General System Maintenance
- Daily Cleaning Procedure
- Daily Flushing Procedure
- Troubleshooting
- General Troubleshooting
- Spray Pattern Troubleshooting
- Service
- Disassembly
- Reassembly
- Parts
- GG0 Series Tip Selection Charts
- Sealer Application Tip and Air Cap Selection Charts
- Shower Tip
- Streaming Tips
- Single Orifice Fan Pattern Spray Tips
- Accessories
- Dimensions
- Mounting Hole Layout
- Technical Data
- Graco Standard Warranty
- Graco Information