Henny Penny 600 EN - Manual (Page 17)

Model 500/561/600
Timer Programming
1.
Anytime the cook time is displayed, press under the appropri-
ate display to change the cook time.
Set-Point Temperature Programming
1.
Press once to view the actual shortening temperature and
press again to view the set-point temperature.
2. While the set-point temperature is in the display, press
to change the set-point temperature.
If “LOCK” shows in display when pressing ,
the controls are locked and must be unlocked before changing
the time or set-point temperature. See C1000 Special
Programming Section.
3-6. C1000 PROGRAMMNG
INSTRUCTIONS
3-7. C1000 SPECIAL
PROGRAMMNG
Special Programming is used to set the items below:
ƒ
Fahrenheit or Celsius
ƒ
Initialize System
ƒ
Lock or Unlock Controls
ƒ
Fryer Type – Open or Pressure
ƒ Heat Source – Electric; Gas w/electronic ignition
ƒ
Vat Type - Full or Split
ƒ Oil Type - Solid or Liquid
1. To enter Special Programming, turn off power switch
(either side). Press and hold and turn the power
switch back on.
2. “SPEC” “PROG” followed by, “DEG” “°F” or “°C”.
Use to choose “°F” or “°C”.
3. Press and “INIT” shows in the display.
Press and hold and display shows “In-3”,
“In-2”, “In-1” followed by “Init Sys” “DONE DONE”. The
controls now are reset to factory parameters, the time set to
0:00 and temperature 190°F or 88°C.
4. Press and “LOCK” or “UNLOCK” shows in the dis-
plays. Use to choose “LOCK” or “UNLOCK.
5. Press and “FRYR” shows in left display and the right
display should show “PRES”. Use to change from
“OPEN” to “PRES” if needed.
1209 3-17