Hitachi CP-X265 - Manual (Page 30)

30
IMAGE Menu
IMAGE Menu
Item Description
ASPECT
Using the buttons ▲/▼ switches the mode for aspect ratio.
For an RGB signal
NORMAL у 4:3 у 6:9 у SMALL
For a video signal, s-video signal or component video signal
4:3 у 6:9 у 4:9 у SMALL
For a no signal
4:3 (fixed)
• The NORMAL mode keeps the original aspect ratio of the signal.
OVER SCAN
Using the buttons ▲/▼ adjusts the over-scan ratio.
Large (It reduces picture) ó Small (It magnifies picture)
• This item can be selected only for a video, s-video and component signal.
• When this adjustment is too large, certain degradation may appear
at the frame area of the picture. In such a case, please adjust small.
V POSITION
Using the buttons ▲/▼ adjusts the vertical position.
Up ó Down
• Over-adjusting the vertical position may cause noise to appear
on the screen. If this occurs please reset the vertical position to the
default setting. Pressing the RESET button when V POSITION is
selected will reset the V POSITION to the default setting.
For a video signal, s-video signal or component video signal
The adjustable range of V.POSITION depends on the OVERSCAN setting.
It is not possible to adjust when the OVERSCAN is set to 0.
H POSITION
Using the buttons ▲/▼ adjusts the horizontal position.
Left
ó Right
• Over-adjusting the horizontal position may cause noise to appear
on the screen. If this occurs please reset the horizontal position to
the default setting. Pressing the RESET button when H POSITION
is selected will reset the H POSITION to the default setting.
For a video signal, s-video signal or component video signal
The adjustable range of H.POSITION depends on the OVERSCAN setting.
It is not possible to adjust when the OVERSCAN is set to 0.
H PHASE
Using the buttons ▲/▼ adjusts the horizontal phase to eliminate flicker.
Right ó Left
• This item can be selected only for an RGB signal or a component
video signal.
With the IMAGE menu, items shown in the table below can
be performed.
Select an item using the cursor buttons ▲/▼ on the
projector or remote control, and press the cursor button ►
on the projector or remote control, or the ENTER button
on the remote control to execute the item. Then perform it
referring to the following table.
/'07=4)$? 
 5'.'%6
#761#&,756':'%76'
#52'%6 
18'45%#0
*2*#5'
*5+<'
*215+6+10 

8215+6+10
2+%674'
+/#)'
+0276
5'672
5%4''0
126+10
0'6914-
'#5;/'07