Hitachi CP-X265 - Manual (Page 50)

50
NETWORK Menu
 5'.'%6
+2#&&4'55
57$0'6/#5-
&#6'#0&6+/'
&*%2  67401((
&'(#7.6)#6'9#;
6+/'&+(('4'0%'
G5*16
+0(14/#6+10
5'48+%'
/'07=4)$?
2+%674'
+/#)'
+0276
5'672
5%4''0
126+10
0'6914-
'#5;/'07
NETWORK Menu
Item Operation
DHCP
(Dynamic Host
Configuration
Protocol)
DHCP TURN ON/TURN OFF:
Use the ▲/▼ buttons to turn DHCP on/off
TURN ON ó TURN OFF
Select TURN OFF when the network does not have DHCP
enabled.
IP ADDRESS
Input the IP ADDRESS :
Use the
▲/▼/◄/► buttons to enter the IP
ADDRESS. This function can only be used
when DHCP is set to “TURN OFF”.
~Note~
IP ADDRESS is a number which identifies this projector on the
network. You cannot have two devices with the same IP ADDRESS
on the same network.
SUBNET MASK
Input the SUBNET MASK :
Use the buttons
▲/▼/◄/► to enter the
same SUBNET MASK of your PC.
This function is available as long as DHCP
is set to “TURN OFF”.
Select [Network] from the main menu to access the following
functions.
NOTE • The factory default setting for DHCP is “TURN ON”. You do not have to set
up [DHCP], [IP ADDRESS], [SUBNET MASK] or [DEFAULT GATEWAY] if your network
has DHCP enabled. (
 User’s Manual - Network Functions)
• If you are not utilizing SNTP (
 User’s Manual - Network Functions), then you must
set the DATE AND TIME during the initial installation. Please refer to the item DATE
AND TIME on the following list.
DHCP
TURN ON
TURN OFF
NOTE Ask with your network administrator before connecting to an existing
access point on your network. Incorrect network settings on this projector may cause
unnecessary troubles on the network.
192. 168. 254
IP ADDRESS
1.
255. 255. 0
SUBNET MASK
255.