Hitachi CP-X265 - Manual (Page 5)

5
AC inlet (
 14)
Power switch (
 17)
Elevator button ( 
9)
COMPONENT
VIDEO ports (

13)
Y
C
B /P B
C R /P R
S-VIDEO port ( 
13)
VIDEO port (
 13)
CONTROL port (
 12)
Elevator foot (
 9)
Rear-Left side
Ports (See below.)
Vent
AUDIO OUT port
(

12)
Ports
AUDIO IN port ( 
12)
(In the default setting, the AUDIO
IN port is the audio port for
the RGB IN port, however, it is
possible to change the settings.
 36)
AUDIO IN3 L/R port ( 
13)
(In the default setting, the
AUDIO IN3 L/R port is the audio
port for the VIDEO, S-VIDEO
and COMPONENT VIDEO
ports, however it is possible to
change the settings.
 36)
RGB IN port (
 12)
NOTE (*) About Restart switch: This projector is controlled by an internal
microprocessor. Under certain exceptional circumstances, the projector may not
operate correctly and the microprocessor will need to be reset. In such a case,
please push the Restart switch by using a cocktail stick or similar, and before
turning on again, make the projector cool down at least 0 minutes without
operating. Only push the Restart switch in these exceptional instances.
Restart switch (*) ( 
62)
Part names
USB port ( 
12)
C R /P R
C B /P B
AUDIO IN
2
AUDIO IN
1
RGB IN
1
RGB IN 2 LAN
CONT ROL
RGB OU
T AUDIO OU
T
USB
VIDEO
S-VI
DEO
AC IN
Kensington lock slot
RGB OUT port ( 
12)
RGB IN port (
 12)
AUDIO IN port (
 12)
(In the default setting, the AUDIO IN port is the audio
port for the RGB IN port, however, it is possible to
change the settings.
 36)
LAN
Y R
L
AUDIO IN3
AUDIO IN1
AUDIO OUT
USB
RGB OUT
AUDIO IN2
VIDEO
S-VIDEO
C B / P B
C R / P R CONTROL
RGB IN2 RGB IN1
K
LAN port (  12)
Used for Ethernet
input/output.
This port is used
when utilizing
network functions.