Horizon Fitness ASCENT TRAINER AT1501 - Manual (Page 5)

BEFORE
YOU BEGIN

INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
ASCENT
TRAINER
OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE YOU
BEGIN
ASSEMBL
Y

INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASCENT
TRAINER
OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
BOLTS (C)
ARC WASHERS (E)
BOLTS (C)
ARC WASHERS (E)
BOLTS (C) WASHERS (D)
AXLE
BOLTS (C)
WASHERS (D)
AXLE BASE RAIL
BASE RAIL
TOP HANDRAIL
MAIN FRAME
REAR
UPRIGHT
BASE RAIL
BRACKET CAPS
BASE RAIL
BRACKET CAPS
WASHER (D)
25 mm
Qty: 4
BOLT (C)
16 mm
Qty: 12
WASHER (D)
25 mm
Qty: 4
BOLT (C)
16 mm
Qty: 12
ARC WASHER (E)
17 mm
Qty: 8
AXLE
Qty: 2
ARC WASHER (E)
17 mm
Qty: 8
Side View
Side View
HARDWARE BAG 2 CONTENTS:
ASSEMBLY STEP 2:
Open HARDWARE BAG 2.
Attach the REAR UPRIGHTS to the BASE FRAME using 4 BOLTS (C), 4 WASHERS (D), 4 BASE RAIL CAPS and
2 AXLES.
NOTE: Assemble the TOP HANDRAILS so they are parallel to the floor. Do not assemble with the TOP
HANDRAIL resting on the floor.
NOTE: Assemble the REAR UPRIGHTS so they curve toward the MAIN FRAME as illustrated.
Partially thread the
TOP HANDRAILS to the REAR UPRIGHTS using 8 BOLTS (C) and 8 ARC WASHERS (E).
A
B
C
INCLINE ARM
BOLTS (F)
TOP HANDRAIL
NUTS (G)
INCLINE ARM
BOLTS (D)
TOP HANDRAIL
BOLT (F)
25 mm
Qty: 4
BOLT (F)
25 mm
Qty: 4
NUT (G)
8 mm
Qty: 4
NUT (G)
8 mm
Qty: 4
HARDWARE BAG  CONTENTS:
ASSEMBLY STEP :
Open HARDWARE BAG 3.
Attach each TOP HAND RAIL to the INCLINE ARM using 4 BOLTS (F) and 4 NUTS (G). To make assembly
easier, lightly tighten all four bolts to begin, then tighten firmly after all bolts have been started.
NOTE: The INCLINE ARM extends from the front of the REAR MAST COVER.
NOTE: Tighten all hardware from Assembly Step 2.
A
B
ASSEMBLY STEP 2 ASSEMBLY STEP 
AT1501_Rev.2.6.indd 8-9 7/31/08 12:43:22 PM