Horizon Fitness ASCENT TRAINER AT1501 - Manual (Page 6)

BEFORE
YOU BEGIN
10
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
ASCENT
TRAINER
OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE YOU
BEGIN
ASSEMBL
Y
11
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASCENT
TRAINER
OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
BOLTS (H)
BOLTS (H)
BOLT (C)
WASHER (I)
BOLT (C)
WASHER (I)
MAIN FRAME
RIGHT UPPER
HANDLEBAR
LEFT UPPER
HANDLEBAR
REAR MAST COVER
HANDLEBAR SHAFT
WAVY WASHER (J)
LEFT LOWER
HANDLEBAR
RIGHT LOWER
HANDLEBAR
BOLT (C)
WASHER (I)
BOLT (H)
20 mm
Qty: 8
BOLT (H)
20 mm
Qty: 8
WASHER (I)
34 mm
Qty: 2
BOLT (C)
16 mm
Qty: 2
WASHER (I)
25 mm
Qty: 8
BOLT (C)
16 mm
Qty: 2
WAVY WASHER (J)
23 mm
Qty: 2
WASHER (I)
25 mm
Qty: 8
HARDWARE BAG  CONTENTS:
ASSEMBLY STEP :
Open HARDWARE BAG 4.
Slide 1 WAVY WASHER (J) onto each HANDLEBAR SHAFT.
Slide the LEFT LOWER HANDLEBAR onto the HANDLEBAR SHAFT. Be sure the LEFT LOWER HANDLEBAR is
positioned the same as shown in the diagram.
Slide the
LEFT UPPER HANDLEBAR onto the HANDLEBAR SHAFT. Using 4 BOLTS (H) connect the UPPER and
LOWER HANDLEBAR as shown in the diagram. Do not tighten any bolts until all 4 are started.
Secure the handlebar assembly using 1
WASHER (I) and 1 BOLT (C).
Repeat STEPS C-E on the opposite side.
NOTE: Be sure to attach WASHER (I) as shown in STEP E DIAGRAM.
A
B
C
D
E
F
ASSEMBLY STEP 
WASHER (L)
WATER BOTTLE HOLDER
BOLTS (C)
PRE-ATTACHED BOLTS
WASHER (L)
BOLTS (C)
CONSOLE MAST
MAIN FRAME BRACKET
CONSOLE
BOLT (C)
16 mm
Qty: 4
BOLT (C)
16 mm
Qty: 4
WASHER (L)
18 mm
Qty: 4
BOLT (K)
12 mm
Qty: 4
WASHER (K)
34 mm
Qty: 4
BOLT (J)
12 mm
Qty: 4
HARDWARE BAG 5 CONTENTS:
ASSEMBLY STEP 5:
Open HARDWARE BAG 5.
Run wires from MAIN FRAME BRACKET through the CONSOLE MAST.
Attach CONSOLE MAST to the MAIN FRAME BRACKET using 4 BOLTS (C) and 4 WASHERS (L).
Attach wires to back of CONSOLE.
NOTE: Do not pinch wires.
Attach
CONSOLE to the CONSOLE MAST using 4 PRE-ATTACHED BOLTS.
Slide WATER BOTTLE HOLDER into back of CONSOLE.
A
B
C
D
E
F
ASSEMBLY STEP 5
BOLTS (H)
BOLTS (H)
BOLT (C)
WASHER (I)
BOLT (C)
WASHER (I)
MAIN FRAME
RIGHT UPPER
HANDLEBAR
LEFT UPPER
HANDLEBAR
REAR MAST COVER
HANDLEBAR SHAFT
WAVY WASHER (J)
LEFT LOWER
HANDLEBAR
RIGHT LOWER
HANDLEBAR
BOLT (C)
WASHER (I)
STEP E DIAGRAM
AT1501_Rev.2.6.indd 10-11 7/31/08 12:43:34 PM