Horizon Fitness ASCENT TRAINER AT1501 - Manual (Page 8)

BEFORE
YOU BEGIN
1
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
ASCENT
TRAINER
OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE YOU
BEGIN
ASSEMBL
Y
15
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASCENT
TRAINER
OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
NUT (G)
WASHER (L)
BOLT (N)
SPACER
SPACER
ROD BEARING
SHAFT
LINK ARM
LOWER
HANDLEBAR
WASHER (L)
18 mm
Qty: 2 BOLT (N)
45 mm
Qty: 2
ROD BEARING
SHAFT
Qty: 2 SPACER
Qty: 4 NUT (G)
8 mm
Qty: 2
HARDWARE BAG  CONTENTS:
ASSEMBLY STEP :
Open HARDWARE BAG 9.
Slide 1 ROD BEARING SHAFT into the joint end of right LINK ARM.
Fit 1 SPACER on each side of each ROD BEARING SHAFT after the ROD BEARING SHAFTS are in LINK ARM.
Attach right LINK ARM to the right LOWER HANDLEBAR using 1 BOLT (N), 1 WASHER (L) and 1 NUT (G).
Repeat on opposite side.
A
B
C
D
E
ASSEMBLY STEP 
CRANK
PACKAGING PLASTIC
WASHER (D)
WAVY WASHER (J)
RIGHT SWING ARM
BOLT (C)
CRANK CAP
SWING CAP
TOP HANDRAIL
WASHER (D)
AXLE
BOLT (C)
WASHER (D)
SWING CAP
BOLT (C)
PEDAL ARM
LINK ARM
BOLT (C)
16 mm
Qty: 6
WASHER (D)
25 mm
Qty: 6
WAVY WASHER (J)
29 mm
Qty: 2
AXLE
Qty: 2
HARDWARE BAG  CONTENTS:
ASSEMBLY STEP :
Lay waste packaging plastic over the BASE RAIL. This will prevent the PEDAL ARM assembly from scratching
the ascent trainer’s paint.
Open
HARDWARE BAG 8.
Place 1 WAVY WASHER (J) onto CRANK.
Attach the right PEDAL ARM of the assembly to the right CRANK using 1 WASHER (D) and 1 BOLT (C).
Attach right SWING ARM to TOP HANDRAIL using 2 SWING CAPS, 2 BOLTS (C), 1 SHAFT and 2 WASHERS (D).
Attach the CRANK CAP to the CRANK
Repeat on opposite side.
A
B
C
D
E
F
G
ASSEMBLY STEP 
AT1501_Rev.2.6.indd 14-15 7/31/08 12:43:49 PM