Hand Held Products DOLPHIN 7600 - Manual (Page 30)

3 - 14 Rev D
10/18/2007
Dolphin® 7600 User’s Guide
Bottom Panel Features
Hand Strap Slot
There is an adjustable, elastic hand strap available for purchase with the Dolphin 7600 terminal. When installing the
hand strap, you loop the elastic strip through this slot. For instructions, see
Attaching the Hand Strap on page 3-15.
I/O Connector
The I/O mechanical connector is designed to work exclusively with Dolphin 7600 peripherals and cables. This
connector powers the terminal, charges the main battery, and facilitates communication. This connector supports
full speed USB 1.1 communication (up to 12 Mbps) and RS-232 communications with a maximum speed of
115Kbps and seven baud rate settings.
Through this connector, you can communicate with a host workstation via Microsoft ActiveSync; see ActiveSync
Communication on page 6-3.
The I/O connector supports the following signals:
• Data Carrier Detect
• Received Data
• Transmitted Data
• Data Terminal Ready
• Signal GND
• Data Set Ready
• Request To Send
• Clear To Send
• Ring Indicator
• USB GND
• USB +5V
• USB D+
• USB D-
Note: Signals referenced are for a DTE device.
I/O Connector Hand Strap Slot