Horizon Fitness CLUB SERIES E700 - Manual (Page 6)

BEFORE
YOU
BEGIN
10
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
ELLIPTICAL OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE YOU
BEGIN
ASSEMBL
Y
11
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ELLIPTICAL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
ASSEMBLY STEP 5 ASSEMBLY STEP 
NOTE: There is NO hardware bag for this step.
A) Slide LOWER HANDLEBAR onto CONSOLE MAST and align NOTCH with TAB making sure bars are joined
together completely. Secure LOWER HANDLEBAR to CONSOLE MAST using
PRE-ATTACHED SET SCREWS.
B) Slide UPPER HANDLEBAR onto CONSOLE MAST and align NOTCH with TAB making sure bars are joined
together completely. Secure UPPER HANDLEBAR to CONSOLE MAST using PRE-ATTACHED SET SCREWS.
C) Repeat on other side.
After handlebars are assembled they will rotate freely – be cautious. Until the
machine is fully assembled, do not grab the handlebars for support.
WARNING
PRE-ATTACHED SCREWS
TAB
UPPER HANDLEBAR
HANDLEBAR JOINT
LOWER HANDLEBAR
NOTCH
SCREW (E)
20 mm
Qty: 4
SCREW (E)
15 mm
Qty: 8
SCREW (G)
29 mm
Qty: 6 SCREW (H)
15 mm
Qty: 2
HARDWARE BAG FOR STEP 5 CONTENTS :
STEP 5
A) M5x20mm Screw
quantity:4
B) M5x15mm Screw
quantity:8
quantity:6
D) M8x15mm Screw
quantity: 2
C) 29mm wave washer
SCREW (E)
LOWER LINK ARM
FOOTPAD
A) Open HARDWARE BAG FOR STEP 5.
B) Attach FOOTPAD to LOWER LINK ARM using 4 SCREWS (E).
C) Repeat on other side.
E800 SHOWN
E500-E800_Rev.1.7.indd 10-11 4/27/07 1:43:50 PM