Hobart Welding Products OM-1594 - Manual (Page 28)

OM-1594 Page 24
4-15. Adjusting Wire Feed Starting Speed
To adjust wire feed starting speed,
proceed as follows:
1 Motor Speed Control Board
PC1
2 Motor Start Control
Potentiometer R3
Remove protective white rubber
cap before making adjustment.
Adjust potentiometer using a small
nonconductive screwdriver. Turn
potentiometer clockwise to
increase time it takes the motor to
ramp up to speed.
Reinstall side panel.
1
2
Top Of PC1
Ref. 801 557 / 197 716
Tools Needed:
Nonconductive
1/4 in