Horizon Fitness E900 - Manual (Page 5)

BEFORE
YOU
BEGIN

INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
ELLIPTICAL OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE YOU
BEGIN
ASSEMBL
Y
9
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ELLIPTICAL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
BOLT (A)
FRONT STABILIZER TUBE
MAIN FRAME
ASSEMBLY STEP 1
A) Open HARDWARE BAG FOR STEP 1.
B) Attach the FRONT STABILIZER TUBE to the MAIN FRAME using 2 BOLTS (A).
ASSEMBLY STEP 2
MAIN FRAME
CONSOLE MAST
CONSOLE MAST BOOT
CONSOLE WIRES
BOLT (B)
SPRING WASHER (C)
FLAT WASHER (D)
BOLT (B)
SPRING WASHER (C)
ARC WASHER (E)
PRE-ATTACHED
ALIGNMENT BOLT
BOLT (B)
20 mm
Qty: 6
BOLT (F )
12 mm
Qty: 2
SPRING WASHER (C)
15 mm
Qty: 6 FLAT WASHER (D)
18 mm
Qty: 4
ARC WASHER (E)
17 mm
Qty: 2
angle view
HARDWARE BAG FOR STEP 2 CONTENTS :
WATER BOTTLE HOLDER
CONSOLE MAST
BOLTS (F)
BOLT (A)
20 mm
Qty: 2
HARDWARE BAG FOR STEP 1 CONTENTS :
Open HARDWARE BAG FOR STEP 2.
Remove PRE-ATTACHED ALIGNMENT BOLT from CONSOLE MAST.
Slide CONSOLE MAST BOOT onto the bottom of the CONSOLE MAST.
Put ALIGNMENT BOLT back into CONSOLE MAST, screwing it in only half way.
Carefully pull the CONSOLE WIRES through the CONSOLE MAST using the twist tie located inside the
CONSOLE MAST.
Attach the CONSOLE MAST to the MAIN FRAME using 6 BOLTS (B), 6 SPRING WASHERS (C),
4 FLAT WASHERS (D) and 2 ARC WASHERS (E).
DO NOT PINCH WIRES!
Attach the WATER BOTTLE HOLDER to the mast using 2 BOLTS (F).
A.
B.
C.
D.
E.
F.
G.
E900_E1200_Rev.2.7.indd 8-9 6/16/08 9:45:39 AM