Horizon Fitness E900 - Manual (Page 8)

BEFORE
YOU
BEGIN
1
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
ELLIPTICAL OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE YOU
BEGIN
ASSEMBL
Y
1
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ELLIPTICAL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
ASSEMBLY STEP 
LOWER HANDLEBAR
SPACER RING (O)
SPACER (N)
BOLT (M)
WASHER (P)
NUT (Q)
LOWER LINK ARM
PRE-ATTACHED
HARDWARE
LOWER LINK ARM
SPACER (N)
SPACER RINGS (O)
LOWER
HANDLEBAR
A) Open HARDWARE BAG FOR STEP 7.
B) Slide SPACER (N) into LOWER LINK ARM.
C) Place 2 SPACER RINGS (O) on both sides of SPACER (N). While holding
SPACER RINGS (O), slide LOWER LINK ARM into bottom end of LOWER
HANDLEBAR.
D) Insert 1 BOLT (M) into LOWER HANDLEBAR and secure using 1 WASHER
(P) and 1 NUT (Q).
E) Repeat on other side.
ASSEMBLY STEP 
SCREWS (R)
OUTSIDE ELBOW COVER
INSIDE ELBOW COVER
SCREWS (S)
OUTSIDE ELBOW COVER
INSIDE ELBOW COVER
SCREWS (S)
SCREWS (R)
A) Open HARDWARE BAG FOR STEP 8.
B) Attach the INSIDE and OUTSIDE ELBOW COVERS to the right LOWER LINK ARM using 2 SCREWS (R).
C) Tighten the ELBOW COVERS together at the front using 1 SCREW (S).
D) Repeat on other side.
SCREW (R)
8 mm
Qty: 4 SCREW (S)
10 mm
Qty: 2
HARDWARE BAG FOR STEP  CONTENTS :
BOLT (M)
45 mm
Qty: 2
SPACER (N)
Qty: 2
SPACER RING (O)
Qty: 4
WASHER (P)
18 mm
Qty: 2 NUT (Q)
18 mm
Qty: 2
HARDWARE BAG FOR STEP  CONTENTS :
Confirm that the
LOWER HANDLEBAR
and the
LOWER LINK ARM
are marked R. The left
side is marked L.
E900_E1200_Rev.2.7.indd 14-15 6/16/08 9:46:14 AM