Hayes Microcomputer Products DIVA T/A - Manual (Page 41)

DIVA T/A PC Card User’s Guide 41
Parameter Description
Connect using this
protocol Specifies the ISDN connection protocol
you want to use (it must match the protocol
on the receiving system). For most
connections, the default Multilink PPP
should be used. If the default is not
supported, PPP for single B-channel
connections, V.120 and V.110 can also be
used.
Both PPP and Multilink PPP require that a
PPP communications stack be installed on
your computer.
If your workstation is configured as a
Windows for Workgroups Remote Access
Service (RAS) client, you must configure
the V.120 rate adaption protocol on both
the DIVA T/A workstation and on the
remote device (RAS Server ISDN adapter).
Note: For security purposes, Multilink PPP
does not support the callback feature used
by some servers.
Warning: When using Multilink PPP for
incoming calls, only SPAP or PAP
authentication are supported.
(Windows NT only) To support incoming
calls with Windows NT RAS Server, you
must enable the parameter “Allow clear
text authentication” in the RAS Server
setup. Refer to the RAS online help for
information on how to configure this
parameter.
Telephone Number
(1
st /2 nd Number)
Specifies your ISDN number(s). You can
specify either one or two ISDN numbers
(1
st and 2 nd ). Specify two numbers if your
ISDN provider assigns two different
numbers.
Note: If you are using a North American
version of the DIVA T/A and your line
supports AutoSPID, ISDN numbers are
automatically detected. For more
information on AutoSPID, refer to page 76.