Hayes Microcomputer Products DIVA T/A - Manual (Page 55)

DIVA T/A PC Card User’s Guide 55
Updating or Changing the Regional DIVA T/A
Firmware (DOS, and OS/2)
Warning: When updating your DIVA T/A firmware, the current
profile configurations may get erased. Write down your settings,
which can be viewed with the AT command AT&V or AT@MENU,
using any terminal emulation program. From the displayed
information, record your ISDN parameter values on a sheet of paper.
This section shows you how to update or change the DIVA T/A’s
regional firmware. To update your DIVA T/A, follow the steps below:
1 Start terminal-emulation software capable of X-Modem transfer.
2 Configure the terminal to talk to the Eicon T/A COM port.
3 Type AT$Z.
4 At the '>>' prompt, type $Load.
Note: The $Load command is CASE-SENSITIVE.
5 Start the X-Modem transfer, if you are only changing your
regional firmware, select either ROM0NA.ELM for North
America, or ROM0ROW.ELM for the International (Excluding
North America) version from the \FIRMWARE directory on the
DIVA T/A CD.
If you are updating your firmware, select either the updated
ROM0NA.ELM or ROM0ROW.ELM from wherever it is
located, e.g. your \TEMP directory, or from an updated
firmware disk.
6 Wait for the reply that denotes the successful transfer.
Warning: Powering off your system immediately following the
transfer could damage your DIVA T/A card. Wait just a few
moments until the delay following the transfer is complete.
7 Type AT to exit the '>>' prompt.
8 If required, reconfigure your card.