HP 5992-3838 - Manual (Page 65)

C Configuring the WBEM Provider Password
Introduction
WBEM is a management information retrieval and command protocol. Application Discovery
uses a WBEM provider to allow the central management server (CMS) to send commands to
agents running on managed nodes. Sending a WBEM command to a managed node requires
remote login from the CMS to a managed node.
An authorized user name and matching password are used to log in. The users who are authorized
to access the Application Discovery WBEM provider on a managed system are the same users
who are registered with HP Systems Insight Manager (HP SIM) to access system metrics.
Ensure that the following WBEM user IDs are registered with HP SIM: root, bin, and amgr.
Registering any one of these IDs enables the WBEM provider to be connected to from the
Application Discovery CMS. Every registered WBEM user must have a valid password.
To register a WBEM user ID and password with HP SIM, do the following:
•
For global configuration across multiple machines, select Options
→Protocol Settings→Global
Protocol Settings .
Find the section "Default WBEM Settings" and edit as needed.
• For an individual managed node, select Options
→Protocol Settings→System Protocol
Settings
Select the target system.
When the configuration screen is displayed, find the section “WBEM Settings”, and edit as
needed.
In case of failure Any failed login attempts discovered by the Application Discovery user
interface create an entry in the HP SIM audit log. The WBEM provider on each managed system
is responsible for logging failed WBEM login attempts.
Introduction 65