Servicing your outboard motor – HONDA Outdoor Motor BF90D User Manual
Page 103
101
SERVICING YOUR OUTBOARD MOTOR
FUEL FILTER
(inside strainer cup)
FUEL INTAKE
SIDE JOINT
EDGE AT
THE BASE
OF JOINT
ALIGNMENT
MARK ON THE
SUSPENSION
SUSPENSION STRAP
Prime the engine using the priming
bulb (refer to page
). Check for
fuel leaks.
Repair any fuel leaks if necessary.
If loss of power or hard starting are
found to be caused by excessive
water or sediment accumulation in
the fuel filter, inspect the fuel tank.
Clean the fuel tank and tank filter if
necessary. It may be necessary to
drain the fuel tank completely and
refill with fresh gasoline.
Assemble the fuel filter by
aligning the edge at the base of the
fuel intake side joint of the fuel
filter with the alignment mark on
the suspension as shown above.
Install a new fuel filter in the
reverse order of removal.
6.
7.
08/08/04 18:53:50 31ZY9600_102