Honeywell HRSD16 User Manual
Page 53
Configuration
Document 800-00918
Rev F
53
02/08
Figure 3-25
Port Numbers Setup Screen
6.
Change the numbers by highlighting them and pressing
to select the number
field. Use the UP and DOWN arrows to increase or decrease the number value.
The factory default Port settings are:
Remote Admin: 8200
Remote Callback:8201
Remote Watch: 8016
Remote Search:10019
Note
You need to get the appropriate Port Numbers for each RASplus
or a related program (Admin, Callback, Watch, and Search) from
your network administrator.
Note
The system restarts automatically after changing the port
settings.
Note
Do NOT use the same port number for two different programs. If
you do, the DVR cannot be connected with the PC running
RASplus.
Caution
When changing the port settings, you must change the port
settings on the PC running RASplus as well. Refer to the RASplus
manual for details.
Using the Current LAN Settings Using DHCP
Select DHCP from the LAN Type field, highlight Save, and then press
. The DHCP
(Dynamic Host Configuration Protocol) network reads and configures the current IP
address of the DVR.