Hitachi VM-H81A - Manual (Page 29)

Getting Started
29
run.
Note: When the remaining tape time becomes less than about three minutes,
TAPE END flashes in the viewfinder.
Lens Cap
Attach the lens cap to protect the lens when carrying or storing the
camcorder. During shooting attach the lens cap as shown in the figure to
prevent it from being lost.
Using the Microphone Cap
6
Be sure to attach the microphone cap if you rinse the camcorder with water after
using it. If water pressure is applied to the microphone directly, it could cause
damage to the microphone.
Position the microphone cap as shown in the figure and put it on the microphone
securely until a click is heard.
Attaching the Terminal Cover
The terminal cover protects the terminal at the bottom of the camcorder
from damage, dirt, dust, etc.
Attach the terminal cover if you are not using the external power cord.
NOTE: Before attaching the terminal cover, check that there is no sand, water
or dirt adhering to the terminal. If anything adheres to the terminal, use the
brush (provided) or a soft cloth to wipe it off completely.