Hitachi VM-H81A - Manual (Page 53)

Advanced Techniques
53
has been set, the VCR channel is counted up automatically.
Note: Your VCR should have an infrared remote control.
Note: If the channel on the VCR does not change with the above operation,
you need to switch the remote control code of your VCR. Refer to the VCR's
instruction manual. If the channel still does not change after you have
changed the VCR's remote control code, the edit remote control cannot
operate your VCR.
VCR Brands Press VCR SET and This Button
Hitachi REVERSE
Sony PROGRAM
Panasonic FORWARD
Toshiba IN
Mitsubishi COPY START
Sanyo OUT
Sharp
NEC
JVC
Akai A/V DUB
Gold Star
PHILIPS
RCA DISPLAY
Zenith COUNTER RESET
Magnavox TITLE ON/OFF
Note: The remote control code is held in memory until it is changed or the
batteries are replaced.
Note: Point the remote control straight at the VCR's infrared receiver for
operation.
Note: Use the remote control indoors. When the infrared receivers of the
VCR and camcorder are exposed to direct sunlight or strong artificial light, the
remote control may not operate correctly.
Note: The remote control cannot be operated if there is an obstacle between
the remote control and infrared receiver. Especially, be careful of this during
dubbing.
Note: When the edit remote control is connected to the camcorder, the
buttons marked * in the figure above perform the same operations as those of
the other remote control provided.
Operation
You can select up to four different scenes or segments to be copied at one
time.