HP 403349-003 User Manual
Page 23
Removal and replacement procedures 23
o
T-25 Torx driver
o
Wire cutters
•
Condensation pump and sensors
o
T-25 Torx driver
o
Phillips screwdriver
•
Fan unit
o
T-25 Torx driver
•
Flow meter paddle-wheel sensor
o
T-25 Torx driver
o
Wire cutters
o
Water hose fitting wrench (included with your original MCS unit)
o
Counter hold wrench (included with your original MCS unit)
•
Heat exchanger unit (HEX) with coupler
o
T-25 Torx driver
o
Water hose fitting wrench (included with your original MCS unit)
o
Counter hold wrench (included with your original MCS unit)
•
Heat exchanger unit (HEX) with ball valves
o
Adjustable wrench or pipe wrench
o
T-25 Torx driver
•
HEX coupling
o
T-25 Torx driver
o
Water hose fitting wrench (included with your original MCS unit)
o
Counter hold wrench (included with your original MCS unit)
o
Flathead screwdriver
o
Utility knife
•
Magnetic solenoid valve
o
T-25 Torx driver
o
Phillips screwdriver
•
Management module
No tools are required for this procedure.
•
Operator display
o
8-mm socket
o
Small Flathead screwdriver
•
Water group controller
o
T-25 Torx driver
o
Flathead screwdriver
o
8-mm socket
•
Water inlet coupling