HP STORAGEWORKS XP24000 - Manual (Page 40)

Description Item
Lists hosts in the security group in which the specified volume is registered.
• No. A sequential number associated with a host.
NOTE:
Each table row usually shows information about a host. However, if a host is
attached to the disk subsystem via a channel extender, the table row shows
information about the channel extender.
• Type/Model indicates the type and the model number of a host (or a channel extender).
The Type appears on the left of the slash (/). The Model number appears on the right of the
slash. Before the Type/Model, an icon indicates the registration status of the host in these
ways:
• SEQNUMBER indicates the node ID of a host (or a channel extender).
• LPAR indicates the logical partition number of a host. Logical partitions are virtual systems
created as a result of sectioning a computer's memory into separate units.
• Vendor indicates the vendor of a host. Vendors include FJT (Fujitsu), IBM, HTC (Hitachi),
and CNT(Ex). If CNT(Ex) appears, the Type/Model column indicates the type and the
model number of a channel extender, and the SEQNUMBER column indicates the node ID
of the channel extender.
Host table
Closes the dialog box. OK
The LDEV Group to Security Group Dialog Box
The LDEV Group to Security Group dialog box ( Figure 21 ) appears when you right-click an item in
the tree view of the Volume Security window ( Figure 4 ) and then select List -> LDEV Group to Security
Group from the pop-up menu.
NOTE:
However, the List -> LDEV Group to Security Group pop-up command does not display if you
double-click a security group and then right-click a host group or LDEV group from immediately below
the security group.
This dialog box enables you to specify an LDEV group and then displays security groups in which the
specified LDEV group is registered (see
“
Locating Security Groups that Contain a Specified LDEV Group ” on page 47).
Using the Volume Security GUI 40