HP 3000dtn - Manual (Page 183)

ENWW
B-13
RESEND UPGRADE Status The firmware upgrade process was not
successful. Please send the firmware upgrade
file again.
RESETTING FACTORY
SETTINGS Status The printer is resetting the menu settings to
factory defaults. Please wait.
SETTING SAVED Status The control panel setting has been saved.
No action required.
SIZE DETECTED BY
TRAY
alternates with
TRAY X
[TYPE][SIZE]
Warning The printer automatically detected the paper
size loaded in Tray X. Only certain standard
sizes, such as A4 and Letter, can be
automatically detected by the printer trays.
No action is required.
TRAY XX EMPTY
[TYPE][SIZE] Warning Please load Tray XX with media.
TRAY XX OPEN Warning Please close Tray XX. If the tray appears to
be closed, it might not be closed properly.
Pull out the tray and close it firmly.
TRAY XX
[TYPE][SIZE] Warning The printer is able to automatically detect the
paper size loaded in Tray XX. Only certain
standard sizes, such as A4 and Letter can be
automatically detected by the printer paper
trays. No action is required.
UNABLE TO MOPY JOB
[JOBNAME] Status A request to print multiple copies of a print job
was received. The printer was unable to
accept the request, and only one copy of the
print job will be printed. Possible reasons
could be problems with the memory, hard disk
or configuration. Check to see if a hard disk is
installed in the printer.
UNABLE TO STORE JOB
[JOBNAME] Status A request to store a print job was received.
The printer was unable to accept the request.
Possible reasons could be problems with the
memory, hard disk or configuration. Check to
see if a hard disk is installed in the printer.
USE [TYPE] [SIZE]
FROM TRAY N
INSTEAD? Error This message is shown when you press
(select button) to print the current job from
another tray.
Press
and (up and down arrow button)
to scroll through the list of available trays.
Press
(select button) to select the
desired tray.
Message Type Description