HP KAYAK XM600 - Manual (Page 43)

2 Installing and Replacing Hardware Parts in Your PC Workstation
Completing the Installation of a Mass Storage Device
43
Completing the Installation of a Mass Storage Device
When an IDE Drive
Is Installed 1 Switch on the computer.
2 To verify the configuration of your hard disk drive, press F2 to enter
Setup when the HP logo appears. Once in Setup, select the Advanced
menu, then the IDE Devices submenu. In the Primary Master item, check
that the details for the device have been correctly detected by the Setup
program.
3 Press F3 to save and exit Setup.
4 Refer to the operating system documentation for information on
partitioning and formatting a drive.
5 If an IDE drive is removed, switch on the computer. The system BIOS
will detect that the device is missing. Press
F4 to confirm that you want
to remove the device. The system configuration will be updated
automatically.
When a SCSI Hard
Disk Drive Is
Installed 1 Switch on the computer.
2 To enter the SCSI Configuration Utility press F6 when prompted during
the PC Workstation’s start-up routine.
3 Verify or modify the configuration of your new SCSI hard disk drive.
For more information on configuring a SCSI hard disk drive, refer
to the SCSI Administrator’s Guide available on HP’s web site at
http://www.hp.com/go/kayaksupport.
4 When configuration is complete, exit the SCSI Configuration Utility and
re-boot the computer to save any changes.
When a CD-ROM,
CD-RW or DV-Drive
is Installed 1 Switch on the computer and press F2 when the HP logo appears.
2 In the Setup program, select the Advanced menu, then the IDE
Devices submenu. Check that the CD-ROM drive has been detected on
the IDE channel.
3 Press F3 to save and exit the program.
When a Floppy Disk
Drive Is Installed 1 Switch on the computer and press F2 when the HP logo appears.
2 In the Setup program, select the Advanced menu, then the Floppy
Disk Drives submenu, and check that the drive has been detected.
3 Press F3 to save and exit the program .