Replacing the system board, Removing the system board – HP KAYAK XM600 User Manual
Page 45
2 Installing and Replacing Hardware Parts in Your PC Workstation
Replacing the System Board
45
Replacing the System Board
Removing the System Board
1
Switch off the display and PC Workstation. Disconnect all power cables
and any LAN or telecommunications cables.
2
Remove the PC Workstation’s cover (refer to page 24 for instructions).
3
To ease installation, place your PC Workstation on its side with the
system board facing upwards.
4
Remove the PC chassis retaining bar.
5
Disconnect any cables attached to the system board.
6
Remove the main memory processor and any accessory cards from the
old system board (described in this chapter)
7
Remove the four screws located near the processor sockets.
8
Remove the external screw located on the rear panel near the AGP PRO
slot
.
9
Remove the system board, being careful not to damage the PC’s rear
panel connectors.
10 Unclip the retaining bracket from under the system board. This bracket
must be re-installed on the new system board.
➑
➒
❹
❼