HP KAYAK XM600 - Manual (Page 50)

2 Installing and Replacing Hardware Parts in Your PC Workstation
Replacing the Battery
50
Replacing the Battery
WARNING There is a danger of explosion if the battery is incorrectly installed. For
your safety, never attempt to recharge, disassemble, or burn the old
battery. Replace the battery only with the same or equivalent type
recommended by the manufacturer. The battery is a lithium battery
which does not contain heavy metals. Nevertheless, in order to protect
the environment, do not dispose of batteries in household waste. Please
return used batteries to the shop from which you bought them, or to the
dealer from whom you purchased your PC Workstation, or to HP, so that
they can be either recycled or disposed of in an environmentally sound
way. Returned batteries will be accepted free of charge.
If your PC repeatedly loses its configuration settings you should consider
changing the battery. Replace it with a CR2032 coin type
manganese/lithium battery, available from most PC stores.
To change the battery:
1 Disconnect the PC Workstation’s power supply cord and any connection
to a telecommunications network.
1 Remove the PC Workstation’s cover (refer to page 24).
2 Remove the old battery by sliding it from under the retaining clip(s).
3 Place the new battery in the battery holder and ensure that it is
properly seated. Ensure that the clip holds the battery firmly in
place.
4 Replace the PC Workstation’s cover (refer to page 25). Reconnect all
cables and power cords.
5 Run the Setup program to reconfigure the PC Workstation.
Location of battery