Husqvarna 260 ACX - Manual (Page 26)

26 - English
3. INSTALLATION
Slopes
The boundary wire can be laid across a slope that
slants less than 10 %.
The boundary wire should not be laid across a slope
that is steeper than 10 %. There is a risk of
Automower
® finding it difficult to turn there. The
mower will then stop and show the fault message
Outside working area. The risk is at its greatest in
damp weather conditions, as the wheels can slip on
the wet grass.
However, the boundary wire can be laid across a
slope steeper than 10 % when there is an obstacle
that Automower
® can be permitted to collide with, for
example, a fence or a dense hedge.
Automower ® can mow areas inside
the working area that slope up to
35 % (see picture). Areas that slope
more must be demarcated by the
boundary wire.
When any part of the working area's
boundary slopes more than 10"
(10 cm) per distance metre (10 %),
the boundary wire must be routed
about 16" (40 cm) in on flat ground
before the slope starts.
0-4”
40”
4”-
40”
4”-
0-4”
40” 40”
0-14”
40”
16”