Husqvarna 260 ACX - Manual (Page 70)

70 - English
9. TROUBLE SHOOTING
9. Trouble shooting
9.1 Fault messages
A number of fault messages are listed below that can be shown on Husqvarna Automower ® . If the same
fault occurs frequently: contact your dealer.
Fault message Cause Action
Left wheel motor
blocked Grass or other object has wrapped
around the drive wheel. Check the drive wheel and remove
the grass or other object.
Right wheel motor
blocked Grass or other object has wrapped
around the drive wheel. Check the drive wheel and remove
the grass or other object.
Blade disc blocked Grass or other object has wrapped
around the blade disc. Check the blade disc and remove the
grass or other object.
No loop signal The transformer is not connected to
the mains supply or its miniature
circuit-breaker has tripped. Check the wall socket connection and
whether the miniature circuit-breaker
has tripped.
Reset the miniature circuit-breaker by
removing the transformer’s power
cord from the wall socket, wait
10 seconds and then reconnect the
power cord in the wall socket again.
Boundary wire broken. Check the signal given by the LED on
the charging station. If it flashes the
loop is damaged. Repair the broken
cable using an original waterproof
coupler.
The connection between Automower ®
and the charging station has been
lost.
Place Automower ® in the charging
station and change the PIN-code via
Settings - Security - PIN code
(shortcut 4-1-1). You can use the
same PIN code as earlier.
This may be due to the boundary wire
being routed in the wrong direction
around an island, which blanks out
the signal. Check that the boundary wire has
been routed correctly.
If this occurs in isolated areas it may
be due to interference from metallic
objects (perimeter fence,
reinforcement bar) or buried cables in
the vicinity. Try moving the boundary wire.
Trapped Automower ® has got caught in
something.
Free Automower ® and rectify the
reason for it getting trapped.