Husqvarna 260 ACX - Manual (Page 72)

72 - English
9. TROUBLE SHOOTING
9.2 Fault symptom
If your Automower ® does not work correctly, follow the trouble shooting guide below. If the fault persists;
contact your dealer.
Symptom Cause Action
Uneven mowing
results Automower ® works too few hours per
day.
Increase the mowing time, see 6.4
Timer (2) on page 48.
Working area too large. Try limiting the working area or
extending the working time, see 6.4
Timer (2) on page 48.
Dull blades. Replace all the blades and screws so
that the rotating parts are balanced.
Long grass in relation to the set
cutting height. Increase the cutting height and then
successively lower.
The mower seems to work more at
the top of a slope than at the bottom. Change the Installation shape (3-3)
setting to Open.
Accumulation of grass by the blade
disc or around the motor shaft. Check that the skid plate and blade
disc rotate easily. If not, the skid plate
and perhaps the blade disc must be
removed and the grass and foreign
objects removed. See 8.5 Cleaning
on page 67.
Automower ® runs at
the wrong time
The clock on Automower ® needs to
be set.
Set the clock, see Time and date
(4-3) on page 59.
The start and stop times for mowing
are incorrect. Adjust the start and stop time settings
for mowing, see 6.4 Timer (2) on
page 48.
Automower ® vibrates Unbalanced blade disc or damaged
blades. Inspect the blades and screws and
replace them if necessary.
Automower ® runs,
but the blade disc
does not rotate
Automower ® is looking for the
charging station.
No action. The blade disc does not
rotate when the mower is searching
for the charging station.
The mower mows for
shorter periods than
usual between
charges Grass or a foreign object is blocking
the blade disc or skid plate. Dismantle and clean the skid plate
and blade disc.
Both the mowing and
charging times are
shorter than usual This behavior is normal in high
temperatures (gradually increasing
above 77 °F (25 °C)). No action.
Automower ® starts
mowing directly
outside of the
charging station
instead of following
the loop out
Change corridor width and/or
reversing distance.