HTC Wildfire S EN - Manual (Page 17)

Charging the battery
The battery is partially charged when shipped. Before you turn on and start using
HTC Wildfire S, it is recommended that you charge the battery.
§ The battery is already installed in HTC Wildfire S when shipped. A thin film is
inserted between the battery and the compartment. You need to remove this film
before you can charge the battery.
§ Only the power adapter and USB sync cable provided in the box must be used to
charge the battery.
§ Do not remove the battery from HTC Wildfire S while you are charging it using the
power or car adapter.
1. Plug the power adapter into the USB connector.
2. Plug in the power adapter to an electrical outlet to start charging the battery.
As the battery is being charged, the notification LED shows a solid orange light. The
light turns to solid green when the battery is fully charged.
When you charge the battery and HTC Wildfire S is on, the charging battery icon is
displayed in the status bar. After the battery has been fully charged, the charging
battery icon turns to a full battery icon
.
As a safety precaution, the battery stops charging when it overheats.
Switching the power on or off
Switching the power on
Press the POWER button. Easy.
When you turn on HTC Wildfire S for the first time, you’ll need to set it up.
17 Getting started