Hearth and Home Technologies TIARAI-CES - Manual (Page 34)

Page 34 August 1, 2008 Heat & Glo · Tiara I B & Tiara II B · 7010-149M
#1
Figure 8.23 Place rear log onto the two locating pins located
on the rear log shelf in the back of the fi rebox.
#1
#2
#3
Figure 8.24 Place left and right logs into recesses cut out for
them on the left and right side of the burner. Log installation
is complete.
J. Mineral Wool
Figure 8.25 Apply dime size pieces sparingly along front
edge of burner. Do not completely block ports.
• Follow ember placement instructions in
manual.
• Do NOT place embers directly over
burner ports.
• Replace ember material annually.
Explosion Risk.
WARNING
Improperly placed embers interferes with proper burner
operation.
Place individual pieces of embers in front of and around the
gas log where they can be seen. Space them so that gas can
contact them on all sides. Try to avoid stacking the embers
on top of each other. This will assure maximum brightness
and effi cient use of the catalyst promoting brighter, cleaner
burning embers.
I. Positioning the Logs - Tiara II-B K. Embers
NOTE: Do not block gas ports.
L. Accessories
Install approved accessories per instructions included with
accessories. Refer to Section 12 for appropriate accesso-
ries.
Shock or fi re risk.
Use ONLY optional accessories approved for
this appliance.
• U s i n g n o n - l i s t e d a c c e s s o r i e s v o i d s
warranty.
• Using non-listed accessories may result in a
safety hazard.
• Only Hearth & Home Technologies approved
accessories may be used safely.
WARNING