Hotpoint BS61 MK2 - Manual (Page 33)

WARNING: THIS APPLIANCE MUST BE EARTHED.
(a) The oven unit is designed for mounting at a safe level into an oven housing
which must be secured to the backing wall, or alternatively, in the case of the
single oven unit, under a worktop with or without a hob unit above.
(b) In an oven/hob arrangement where it is proposed to install the oven directly
below the hob. It is advisable that only slimline hobs are used which have the
following maximum depths.
It is most important that the hob installation instructions are strictly observed.
INSTALLATION INSTRUCTIONS
This equipment is designed specifically for domestic purposes and Hotpoint
Limited cannot accept responsibility if used in any other type of installation.
This appliance must not be installed over any appliance that generates heat.
For your own safety, we recommend that your appliance is installed by a
competent person – such as one who is registered with NICEIC (National
Inspection Council for Electrical Installation Contracting). The cooker should be
installed in accordance with the latest Edition of the IEE Regulations.
IMPORTANT
1. GENERAL
Kitchen Worktop thickness
30mm
40mm
40mm +
Maximum hob depth
(from worktop surface vertically down)
55mm
65mm
Worktop thickness + 25mm
33