HONDA SB 2040 - Manual (Page 11)

Assembly and Installation SB2040 Snowblower
I
Install Push Frame to Subframe
1. Position the push frame to the subframe as
shown.
2. Install two 1-5/16" bushings, then install
two 1/2 x 1-1/4" hex bob, 1/2" lock
washers, and two 1/2" flat washers to the
weld nuts on the push frame. Tighten the
two nuts securely.
For clarity, the drive belt is not shown in
this illustration.
Install PTO Clutch Assembly
1.
2.
Position the assembly as shown. Make
sure the belt is fully enclosed inside the
push frame, and the tensioner spring
faces away from the blower head.
Install the assembly to the push frame
using 3/8
x 1" hex bolt, 3/8" lock washer
and 3/8" hex nut in the front (closest to the
blower head) hole, then install a 7/16" x 1
hex bolt, 7/16" lock washer and 7/16" hex
nut to the rear hole in the subframe.
1-5/16" BUSHING (2
7/16" HEX NUT 3/8" HEX NUT
7/16 LOCK WASHER
x 1 HEX BOLT
POP 52152