HONDA SB 2040 - Manual (Page 17)

SB2040 Snowblower
4.
5.
6.
7.
8.
9.
10.
Slowly lift the subframe with the height
adjustment lever, so the hole on the left side of
the subframe aligns with the rear hole on the
u-shaped bracket.
Loosely install a single 3/8 x 1-1/4" bolt through
the rear holes only on each side of the
u-shaped bracket and secure with a 3/8" lock
washer and hex nut.
Make sure the subframe remains on the
outside of the u-shaped bracket.
For clarity, the l-brackets and lawn tractor
frame are not shown in this illustration.
Raise the blower head enough so the forward
holes in the subframe align with the holes on
the tractor frame. Raise or lower the blower
head to align the holes vertically, and push or
pull the blower head to align the holes
horizontally. Install two 1/2 x 1-3/4" hex bolts,
1/2" lock washers and 1/2" hex nuts
Install two 3/8 x 1-1/4" hex bolts, lock washers
and hex nuts into the front holes of the
u-shaped bracket. For clarity, the l-brackets
and lawn tractor frame are not shown in this
illustration.
Securely tighten the 3/8 x 1 -1/4" bolts and
Raise the height adjustment lever as far as
possible. This will not be the highest position on
the lawn tractor; do not force it any higher.
Remove the supports from under the blower
head. Lower the height adjustment lever all the
way down.
Disengage the lockout pin by removing its
spring clip, then pulling the lockout pin out
slightly. You may have to have a helper lift the
blower head slightly to relieve any tension on
the lockout pin.
1/2 X 1-3/4" bolts.
FRONT
1/2" HEX NUT (2)
1/2" LOCK WASHER (2)
1/2 x 1-3/4" HEX BOLT (2)
3/8 HEX NUT (2)
11. Replace the spring clip on the lockout pin to
secure it in the disengaged position.
16
POP 52152 (9610)