HONDA SB 2040 - Manual (Page 33)

Removing the Snowblower SB2040 Snowblower
12. Lower the blower head slightly, then remove the
four bolts that hold the u-shaped bracket to the
subframe.
13. Remove the two spring clips and flat washers from
the lift arms on the lawn tractor, then disconnect
the
two lift plates from the corresponding pins on
the lift arms. Allow the lift plates to pivot and drop
clear
of the arms. Retain the clips and washers to
reinstall the snowblower or mower deck.
14. Remove the snowblower from underneath the
lawn tractor. Remove the four bolts that hold the
u-shaped bracket to the two l-shaped brackets.
SPRING CLIP (2)
FLAT WASHER (2)
MOWER
DECK
LIFTING ARM (2) (on
lawn tractor frame)
The two l-shaped brackets may remain on the
lawn tractor frame; the brackets will not interfere
with the installation and operation of the mower
deck.
3/8 x 1" HEX BOLT (4)
32
POP 52152 (9610)