HP 3C905-TX - Manual (Page 24)

Connecting to a Windows NT Server 3.51
Windows NT Workstation 4.0
Connecting to a Windows NT Server 3.51
Windows NT
Workstation 4.0 Requirements
• HP Vectra with Windows NT Workstation 4.0 Service Pack 3.
• 3COM Etherlink 3C905 Ethernet card and drivers disk ver 2.1.
• Vectra VL8 Driver Name: 3C90X.SYS Size: 74KB Date: 1/09/98
• Vectra VL7 Driver Name: 3C90X.INF Size: 71KB Date: 11/25/96
• Microsoft Windows NT Workstation 4.0 and Service Pack Media. (If you
have a Hewlett-Packard pre-loaded HDD, the media is located at
“C:\I386”)
• Microsoft Windows NT Server 3.51 machine that supports Net BEUI, TCP/
IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
Device Configuration
• Network Driver Optimization Normal
• Full Duplex Auto Select (N-WAY)
• Boot PROM Disabled
• Media Type Auto Select (N-WAY)
Procedure
1 With the HP Vectra turned off, install the 3COM Etherlink 3C905 PCI
Vectra VL8 Vectra VL7
I/O Base Address FCC0h FCC0h (PCI)
Interrupt Request
Level
9 (PCI) 9 (PCI)
c905.bk : ch_8.fb4 Page 1 Thursday, October 22, 1998 9:51 AM