Connecting to a windows nt server 4.0 – HP 3C905-TX User Manual
Page 31
Connecting to a Windows NT Server 4.0
Windows 95 SR2
Connecting to a Windows NT Server 4.0
Windows 95 SR2
Requirements
•
HP Vectra with Plug and Play enabled, running Windows 95 SR2.
•
3COM Etherlink 3C905 Ethernet card and drivers disk ver 2.1.
•
Vectra VL8 Driver Name: OEMSETUP.INF Size: 49.3KB Date: 12/1/97
•
Vectra VL7 Driver Name: El90X.SYS Size: 45KB Date: 3/21/97
•
Microsoft Windows NT Server 4.0 machine that supports Net BEUI, TCP/
IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
Device Configuration
•
Network Driver Optimization Normal
•
Full Duplex Auto Select (N-WAY)
•
Boot PROM Disabled
•
Media Type Auto Select (N-WAY)
Procedure
1 With the HP Vectra turned off, install the 3COM Etherlink 3C905 adapter
card into a PCI slot.
2 Connect network cable media to the 3COM 3C905 card.
Vectra VL8
Vectra VL7
I/O Base Address
FCC0h (PCI)
FC40h (PCI)
Interrupt Request
Level
9 (PCI)
9 (PCI)
c905.bk : ch_10.fb4 Page 1 Thursday, October 22, 1998 9:51 AM