Maintenance schedule, Maintenance – Husqvarna 14 Pro User Manual

Page 17

Advertising
background image

English –

15

Maintenance schedule

The following is a list of the maintenance which should be conducted on the machine. For the items which
are not described in these instructions go to an authorised service workshop.

Check the engine’s oil level

17

●

Check the engine’s cooling air intake

17

●

Check the fuel pump’s air filter

17

●

Check the transmission’s air intake

18

●

Check the transmission’s oil level

18

●

Check and adjustment of the steering wires

19

●

Check the battery

20

●

Check the safety system

20

●

Check screws and nuts

–

❍

Check for fuel and oil leakage

–

❍

Clean the air filter’s pre-filter (foam plastic)

2)

21

●

Check the cutting unit

22

●

Check the tyre pressures (60 kPa)

35

●

Adjust the brakes

20

●

Check the V-belts

–

❍

Change the engine oil

1)

33

●

Lubricate joints and shafts

3)

34

●

Check and adjust the throttle wire

35

●

Replace the air filter’s pre-filter and paper filter

2)

21

●

Replace the oil filter

34

●

Replace the fuel filter

36

●

Replace the plugs

–

❍

Clean the engine’s and the hydrostat’s cooling flanges

2,4)

–

❍

Check the valve clearance

4)

–

❍

Check the valves and seats

4)

–

❍

1)

First change after 8 hours.

2)

During dusty conditions cleaning and replacement should be more frequent.

3)

For daily use of the

machine lubrication should be conducted twice a week.

4)

Conducted by authorised service workshop.

25

50

100

300

MAINTENANCE

!

WARNING!

No service procedures must be conducted on the engine or cutting unit unless:

•

The engine is switched off.

•

The ignition key is removed.

•

The ignition cables are removed from the plugs.

•

The parking brake is applied.

•

The cutting unit is disengaged.

Maintenance

●

= Described in these instructions.

❍

= Not described in these instructions.

Daily

main-

tenance

before start

Page

Maintenance interval

in hours

Advertising