Husqvarna 14 Pro - Manual (Page 25)

English –
23
MAINTENANCE
BioClip 103
1
2
8 9
2. Adjust the unit’s ground pressure by screwing in
or out the adjusting screws located behind the
front wheels on both sides.
The ground pressure should be between 12 and
15 kg.
Checking and adjustment of the cutting
unit’s ground pressure
To achieve the best cutting results the cutting unit
should follow the underlying surface without pres-
sing too hard against it.
The pressure is adjusted with a screw on each side
of the machine.
Adjusting of the cutting unit’s ground pressure is
conducted as follows:
1. Place a set of bathroom scales under the cutting
unit’s frame (front edge) so that it rests on the
scales. If necessary a block can be placed
between the frame and scales so that the sup-
port wheels do not bear any weight.
Installing BioClip 90
In order to install BioClip 90 the drive belt support
wheel must first be removed.
1. Disengage the spring from the tensioning wheel.
3. Remove the locking pin (1) that is located next
to the support wheel.
4. Fit the cutting unit as instructed on the previous
page.