Husqvarna 14 Pro - Manual (Page 22)

20
– English
Adjusting the brakes
The brakes are adjusted as follows:
1. Loosen the lock nuts (1).
2. Adjust the wire using the adjuster screw (2) until
the play on the wire is taken up.
3. Tighten the lock nuts (1).
MAINTENANCE
WARNING!
Poorly adjusted brakes can
result in reduced braking power.
!
Check the level of the battery acid
Check that the level of the battery acid lies between
the markings. Top up the cells with distilled water
only.
WARNING!
Procedures on contact with acid
External: Rinse well with plenty of water.
Internal: Drink large quantities of water or
milk. Contact a doctor as soon as
possible.
Eyes: Rinse well with plenty of water.
Contact a doctor as soon as possible.
Batteries emit explosive gas. Sparks, flames
and cigarettes must absolutely not be
brought into the vicinity of the battery.
!
Check the safety system
The machine is equipped with a safety system which prevents starting or driving the machine unless
someone is sitting in the seat. Check daily that the safety system functions.
This check is carried out by applying the parking brake and raising the cutting unit into the transport position.
Start the engine and get off the machine. When the cutting unit is lowered into the cutting position the engine
should stop.